SEVEN / Guides / DJ gearDeutsch

AIAIAI TMA-2
explained for DJs

AIAIAI TMA-2 Modular Headphone System

A modular headphone you build from four parts. Here is which parts make a booth headphone, which make a studio headphone, and which do both. Then come and hear them at the AIAIAI Experience Centre at SEVEN.

Parts
4speaker units, pads, headband, cable
The sound
Speaker + padsheadband and cable don't change it
Booth pick
TMA-2 DJS02 + E02, high isolation
Studio pick
TMA-2 StudioS05 + E08, open and detailed
Try them
Berlin-Mitteevery part in stock to demo
H · HEADBANDS · SPEAKER UNITE · PADC · CABLESOUND =S + E
01 · THE SYSTEM

Four parts. Two of them make the sound.

Every TMA-2 is built from a pair of speaker units (S), a pair of ear pads (E), a headband (H) and a cable (C). Each part clicks or twists off, and AIAIAI sells every one separately.

The speaker units and the ear pads decide how it sounds and how well it blocks out a loud room. The headband is about comfort and how it survives the booth. The cable is personal choice.

Because the pads change the sound, one headphone with two sets of pads can be a booth headphone on Saturday and a studio headphone on Monday.

BOOTHSTUDIOS02S01S05PUNCHYBALANCEDDETAILEDS11WIRELESS · APP EQ
02 · SPEAKER UNITS

Booth, studio, or the one in between

All four speaker units use a 40mm bio-cellulose diaphragm at 32 ohm, so they all run happily from a mixer, an interface or a phone. The difference is the tuning.

S02 is loud and punchy, for hearing your cue over a club monitor. S05 is AIAIAI's most detailed unit, for mix decisions you can trust. S01 sits in the middle, for DJs who also produce. S11 is wireless, and the EQ in the free AIAIAI Audio app lets you slide it towards either end.

AIAIAI Speaker Driver S02 MKII
BoothS02 PunchyPunchy mid-bass, strong low end, plays very loud with very low distortion.Pair with: E02 on-ear pads, high isolation that stays put when you cue.€80 →
AIAIAI Speaker Driver S01 MKII
BothS01 BalancedBalanced and transparent. Less aggressive than the S02, less forensic than the S05.Pair with: E02 to lean booth, E04 to lean studio.€60 →
AIAIAI Speaker Driver S05 MKII
StudioS05 DetailedAIAIAI's flagship: more high-frequency detail, clearer mids, natural tone.Pair with: E08 Alcantara for an open studio sound, E04 for more isolation.€90 →
AIAIAI Wireless Speaker Driver S11
All threeS11 WirelessBalanced out of the box, then shaped with the 5-band EQ in the AIAIAI Audio app.Pair with: Any pad. Add the X03 transmitter for under 10ms W+ Link latency.€110 →
LEATHER · E02 E04ALCANTARA · E08SEALS · ISOLATESOPEN · BREATHES
03 · EAR PADS

The pads change the sound as much as the speakers

Isolation comes from the seal, not from on-ear versus over-ear. Both leather pads seal well: the on-ear E02 and the over-ear E04 each give you high isolation and a strong low end. The Alcantara E08 breathes and sounds open, but lets the room in, so it lives in the studio.

The fit is about feel. On-ear pads rest on the ear and stay put when you push one cup off to cue, the classic booth move. Over-ear pads surround the ear and stay comfortable for hours, and AIAIAI tunes the E04 a little warmer.

Taking a studio pair to the club? Swap the E08 for E02 or E04 pads first, or you won't hear your cue.

PadFitIsolationSoundPrice
E02Vegan leather, memory foamOn-earPunchy, strong bass€35
E04Vegan leather, memory foamOver-earWarmer low end, very comfortable€50
E08Alcantara, memory foamOver-earOpen and spacious, breathable€55

Provisional ratings, based on AIAIAI's specs. We are testing every pad with a panel of DJs in the store; their verdicts and our own measurements replace these soon.

04 · HEADBAND AND CABLE

Comfort and personal choice

Neither changes the sound. Pick the headband for how long you wear it and how hard you treat it, and the cable for how you like to move in the booth. Every cable twist-locks into the left speaker unit and comes with a screw-on 6.3mm adapter.

05 · THE PRESETS

What's in each box, and who it's for

AIAIAI boxes the most popular combinations as presets. Each one comes with an A01 pouch. Start from the one closest to how you play, then swap parts as you go.

AIAIAI TMA-2 DJ V2 Headphones
Best for the boothTMA-2 DJS02E02H02C02The HD 25 rival: punchy, loud, sealed tight.€200 →
AIAIAI TMA-2 Studio
Best for the studioTMA-2 StudioS05E08H04C02Detailed and open. Low isolation, so not for loud booths.€200 →
AIAIAI TMA-2 DJ XE Headphones
Best all-rounderTMA-2 DJ XES01E02H01C05Balanced sound with booth isolation, 168g. Best value way in.€140 →
AIAIAI TMA-2 Studio XE Headphones
All-rounder, studio firstTMA-2 Studio XES01E04H03C05Balanced sound, comfy over-ear pads that still isolate. Ableton Live Lite included.Back soon →
AIAIAI TMA-2 DJ Wireless Headphones
Does it all, booth firstTMA-2 DJ WirelessS11X03E02H02C05Low-latency W+ Link from the mixer, Bluetooth for the street, app EQ.€300 →
AIAIAI TMA-2 Studio Wireless
Does it all, studio firstTMA-2 Studio WirelessS11X03E04H03C05Record without a cable over W+ Link, Bluetooth away from the desk. Ableton Live Lite included.Back soon →
06 · BUILD YOUR OWN

Three builds we recommend

Presets are a starting point, not a rule. These are the combinations we'd put together for DJs who ask us.

BoothThe club buildS02E02H02C02Loud, sealed, grippy and built to be thrown in a record bag. This is the TMA-2 DJ, and we wouldn't change it.
BothThe weekend and weekday buildS01E02+E08H02C02Balanced S01 on the rugged band. Keep E02 pads on for gigs and swap to E08 for long studio sessions.
StudioThe long-session buildS05E04H03C05The detailed S05 with over-ear pads that still isolate, for producing in a shared room or on the road.

Already own a TMA-2? You don't need new headphones to change the sound. A pair of E08 pads or S05 speaker units turns a booth pair into a studio pair, and the S11 makes it wireless. Want low-latency W+ Link for mixing too? Get the S11 + X03 upgrade kit.

The AIAIAI Experience Centre at SEVEN

SEVEN is an authorised AIAIAI dealer, and we keep the whole TMA-2 range in stock in Berlin-Mitte: every speaker unit, ear pad, headband and cable, plus the presets. Come in, build any combination, and hear it before you buy. Broken a cable before a gig? Replacement parts are on the shelf, same day.

Torstraße 220, 10115 Berlin-Mitte, ten minutes from Rosenthaler Platz. Opening hours and directions →

Deciding between a TMA-2 and the Sennheiser HD 25? We stock both, so you can hear them side by side.

FAQ

AIAIAI TMA-2 questions

Which AIAIAI TMA-2 is best for DJing?

For loud clubs, the TMA-2 DJ: punchy S02 speaker units with on-ear E02 pads for high isolation, a rugged H02 headband and a coiled C02 cable. If you also produce at home, the TMA-2 DJ XE with the balanced S01 speaker units covers both jobs and is the lightest preset at 168g.

Which AIAIAI TMA-2 is best for music production?

The TMA-2 Studio. It uses the S05, AIAIAI's most detailed and natural speaker unit, with open-sounding over-ear E08 Alcantara pads. Those pads isolate poorly, so it is a studio headphone rather than a booth headphone.

What is the difference between the S01, S02, S05 and S11 speaker units?

All four use a 40mm bio-cellulose diaphragm at 32 ohm. The S02 is punchy and loud, for the booth. The S05 is detailed and accurate, for the studio. The S01 is balanced, the compromise for DJs who also produce. The S11 is wireless (Bluetooth plus low-latency W+ Link with the X03 transmitter) and is tuned with a 5-band EQ in the AIAIAI Audio app, so it can do all three.

Do the ear pads change the sound?

Yes, a lot. The speaker unit and the ear pads together define the sound. The leather pads, on-ear E02 and over-ear E04, both seal well for high isolation and a strong low end; the E04 adds comfort and a little warmth. The over-ear E08 Alcantara pads sound open and spacious but let the room in, so an over-ear pad can isolate less than an on-ear one. It is the seal, not on-ear versus over-ear, that decides isolation. The headband and cable do not change the sound.

Is the TMA-2 DJ Wireless fast enough to beatmatch?

With the included X03 transmitter, yes. Plugged into your mixer, the X03 sends audio over AIAIAI's W+ Link with under 10ms of latency. Ordinary Bluetooth has more lag, so use W+ Link or the cable for mixing and Bluetooth for listening.

Do all TMA-2 parts fit each other?

The speaker units, ear pads, headbands and cables of the TMA-2 system are designed to be swapped. You can change the sound of the headphones you already own by swapping the speaker units or pads, or turn any TMA-2 wireless with the S11 speaker units.

Can I try AIAIAI headphones in Berlin before I buy?

Yes. The AIAIAI Experience Centre at SEVEN, Torstraße 220 in Berlin-Mitte, has every TMA-2 speaker unit, ear pad, headband and cable in stock. Try any combination in the store before you buy, or pick up a replacement part the same day.

How does the AIAIAI TMA-2 DJ compare to the Sennheiser HD 25?

Both are on-ear, closed, high-isolation booth headphones with replaceable parts. The HD 25 is the long-standing booth standard with a tight, forward sound. The TMA-2 DJ has a punchier low end and is fully modular, so you can change its sound later by swapping speaker units or pads. We stock both, so you can hear them side by side.

—
0:00
0:00
Buy